購買設計請充值后下載，，資源目錄下的文件所見即所得，都可以點開預覽，，資料完整，充值下載可得到資源目錄里的所有文件。。?！咀ⅰ浚篸wg后綴為CAD圖紙，doc,docx為WORD文檔，原稿無水印，可編輯。。。具體請見文件預覽，有不明白之處，可咨詢QQ:12401814
直齒圓柱齒輪注塑模設計
摘 要：本設計題目為直齒圓柱齒輪注塑模設計，體現了塑料齒輪在受力不大場合代替鋼是很有前景的。所以本設計對我今后深入設計齒輪埋下一定的功力。
本設計運用塑料成型工藝及模具設計的基礎知識，首先分析了塑件的成分及性能要求，為選取澆口的類型做好了準備；然后估算了塑件的體積，便于選取注塑機及確定型腔數量；最后分析了塑件的特征，確定模具的設計參數、設計要點及推出裝置的選取。
本塑件齒輪外側的側孔與開模方向不一致，所以在脫模時必須考慮設計側抽機構，以便開模過程的時，使塑件能順利脫模。本副模具采用推管脫模，一模兩件。一模多件容易降低同軸精度，推桿脫模亦不易保證齒輪精度。
型腔采用鑲拼式組合，這樣便于加工、熱處理，也可以利用其配合間隙來排氣。缺點：強度不高，配合面不好的話容易變形。
關鍵詞：注塑模 澆口 推塊
Spur Gear Injection Mold Design
Abstract: The design entitled spur gear injection mold design, reflects the large plastic gear occasions in lieu of steel is very promising. Therefore, the design of the design of future in-depth gear I planted some skill.
The use of plastic molding process design and die design of the basic knowledge, the first analysis of the plastic parts of the composition and performance requirements, in order to select the type of gate ready; and then estimated the volume of plastic parts for injection molding machine to select and determine the type cavity number; the final analysis of the characteristics of plastic parts, molds to determine the design parameters, design features and the introduction of the selected device.
Plastic parts of the lateral side gear hole direction inconsistent with the open mode, it must be taken into account in the design of Demoulding side pumping in order to open mold process, the plastic parts so that a smooth release. Deputy dies in this release using push tube, a two-mode. A multi-coaxial easy to reduce accuracy, putting Demoulding gear would not be easy to ensure accuracy.?
Combined use of cavity so easy processing, heat treatment, can also make use of its space to tie in with the exhaust. Disadvantages: intensity is not high, with not so easy to surface deformation.
Key words:?Injection Molding? Gate Push block